Our Services

Full rough-in and trim-out for new homes and additions, coordinated with your builder's schedule.

Repairs and modernization for older homes — dead circuits, aluminum, ungrounded outlets and undersized service.

Diagnostic visit to find the actual cause of tripping breakers, flickering lights or dead outlets.

Replace an outdated or maxed-out panel with a properly sized, labeled service ready for future loads.

Recessed, pendant, under-cabinet and fixture work laid out so the room actually lights evenly.

Low voltage exterior lighting for paths, palms, facades and pool decks, on timers or app control.

New fan installs and replacements, including fan-rated box and remote or wall control.

New, replacement and relocated devices — including GFCI, AFCI, USB and smart switches.

Level 2 charger install with the right circuit, conduit run and panel capacity for your vehicle.

Panel-mounted surge protection to shield AV gear, appliances and networking from Florida storm surges.

A central, labeled cabling backbone so every jack, camera and access point terminates in one clean place.

Hardwired network drops for offices, TVs, access points and cameras — faster and more stable than Wi-Fi.

Pre-wire behind the wall before drywall or paint so nothing shows once the equipment lands.

In-wall and in-ceiling speaker runs sized correctly for the distance and amplifier.

PoE camera runs pulled to the ideal angles and back to a single recorder location.

RG6 runs for cable, antenna and satellite, with proper splitting and grounding.

Infrastructure for shades, locks, thermostats, keypads and hubs so devices stay wired and reliable.

Voice, data and control cabling for home offices, ADUs and light commercial spaces.

Flush, tilt or full-motion mounting with power and HDMI concealed inside the wall.

Dedicated theater rooms designed around seating, screen size, acoustics and equipment heat.

5.1 through Atmos configurations tuned for the actual room, not the box diagram.

Flush architectural speakers for whole-home audio that disappears into the ceiling.

Soundbar and subwoofer mounting with hidden wiring and correct audio routing from your sources.

A flexible media space — display, sound, lighting scenes and gear rack — set up and handed over working.

Camera systems with real coverage of doors, driveways and blind corners, plus remote viewing.

Fix dead zones with hardwired access points placed by survey instead of guesswork.

Router, switch, firewall and rack configuration built for streaming, cameras and work-from-home.

Wired doorbell install with proper transformer power and chime compatibility.

Locks, thermostats, sensors, hubs and lighting brought online and grouped into scenes.

Replace mesh guesswork with a wired backhaul router and access point setup that holds up.

Full kitchen work with the electrical, lighting and appliance circuits handled by the same crew.

Bath remodels with proper GFCI protection, ventilation and moisture-rated fixtures.

LVP, tile and laminate installation with prepped, level substrate and clean transitions.

Patching for access holes, water damage and cracks, textured and finished to blend.

Rooms and whole interiors prepped, cut in and rolled with protection over floors and fixtures.

Baseboard, casing, crown, shelving and built-ins fit tight and finished properly.

Punch-list and improvement work that is too small for a GC but too involved for a handyman.